How to Use PanelBuilder 1400e Software for Windows to Configure PanelView Operator Terminals

How to Use PanelBuilder 1400e Software for Windows to Configure PanelView Operator Terminals

PanelBuilder 1400e is a software tool that allows you to create and edit applications for PanelView 1000e, 1200e, and 1400e operator terminals. These terminals are used to monitor and control industrial processes and machines. PanelBuilder 1400e runs on Windows operating systems and supports various communication protocols, such as Data Highway Plus, ControlNet, Ethernet, Modbus, and more.

panel builder 1400e serial 15

In this article, we will show you how to use PanelBuilder 1400e software for Windows to configure PanelView operator terminals with serial 15 communication. Serial 15 is a proprietary protocol that allows communication between Allen-Bradley PLCs and PanelView terminals. Serial 15 uses a 15-pin connector and requires a special cable (Cat. No. 2711-NC13).

Step 1: Install PanelBuilder 1400e Software

To install PanelBuilder 1400e software, you need the following:

• A PC with Windows 95, Windows NT 4.0, or later.

• A CD-ROM drive.

• At least 32 MB of RAM and 50 MB of free hard disk space.

• A VGA or higher resolution monitor.

• A mouse or other pointing device.

To install PanelBuilder 1400e software, follow these steps:

• Insert the PanelBuilder 1400e CD-ROM into your CD-ROM drive.

• Run the SETUP.EXE program from the CD-ROM.

• Follow the instructions on the screen to complete the installation.

• Restart your PC if prompted.

Step 2: Connect Your PC to the PanelView Terminal

To connect your PC to the PanelView terminal, you need the following:

• A PanelView terminal with serial 15 communication (Cat. No. 2711E-T10C15, 2711E-T12C15, or 2711E-T14C15).

• A serial cable with a 15-pin connector (Cat. No. 2711-NC13).

• A serial port on your PC (COM1 or COM2).

To connect your PC to the PanelView terminal, follow these steps:

• Turn off the power to the PanelView terminal and your PC.

• Connect one end of the serial cable to the serial port on your PC.

• Connect the other end of the serial cable to the serial port on the back of the PanelView terminal.

• Turn on the power to the PanelView terminal and your PC.

Step 3: Create or Open an Application in PanelBuilder 1400e

To create or open an application in PanelBuilder 1400e, follow these steps:

• Start PanelBuilder 1400e from the Start menu or by double-clicking the icon on your desktop.

• Select File > New to create a new application or File > Open to open an existing application.

• If you are creating a new application, select the type of terminal you are using (1000e, 1200e, or 1400e) and enter a name for your application.

• If you are opening an existing application, browse to the location of your application file and select it.

• Click OK to open your application in PanelBuilder 1400e.

Step 4: Configure Communication Settings in PanelBuilder 1400e

To configure communication settings in PanelBuilder 1400e, follow these steps:

• Select Communication > Terminal Setup from the menu bar.

• Select Serial Port from the Communication Type drop-down list.

• Select Serial Port #15 from the Port Number drop-down list.

Select PLC-5/SLC e0e6b7cb5c